How to install the camera on the camera slider

　　We have repeatedly emphasized that the biggest challenge for motion capture with tri-axial camera stabilizers comes from vertical bumps. Even if you are standing still, just by moving your arm to shoot a slow translation lens, you will find it hard to avoid the arm floating up and down, so it is still difficult to achieve the effect of a small slide.

sevenoak camera slider

　　Camera Curved Slider SK-CS01
　　Diameter: About 85cm
　　Arc length: About 87cm

　　Max load capacity: 10KG

　　In my opinion, in fact, a word can tell you what to do: The three-axis camera stabilizer installed on the tripod head, set the lock mode and then pan. Most single-handed electronic stabilizers currently on the market have bottom screws that can be mounted on a tripod head. The essence of this method is the use of camera pan-tilt damping to achieve a uniform horizontal shift, while maintaining the vertical height unchanged, the use of stabilizer built-in mode to lock the shooting angle.

　　Is not it easy? Similarly, you can also use the same technique to simulate the small arm up and down or oblique translation, this simple method will undoubtedly greatly enhance the freedom of shooting.


　　However, to be reminded, this method is currently only applicable to smaller one-hand stabilizers, and the use of larger stabilizers requires a more secure and secure way of fixing.

More information about camera stabilizer,camera rig